That's strange because I really did connect fcb's midi out to rolands midi in. The display should say A1 if I connected midi out to midi in. So I did the fcb checkup, (holding 1-3 while powering up), and calibrating the expression pedals. I get the preset to change the program in roland device but I just can't get the pedal to work.

I also have to set midi channel of the expression pedal to 7 right? To do that I have to select preset 1 to do 1 program change and set that function to midi chanel 7 (like the roland vg 99) In order for the fcb to be able to function with roland vg 99 I have to set the midi channel of each function(fcb) to correspond with the midi channel used on the roland vg 99įor instance i use preset 1 and I want it to change the program on the vg 99 and use the expression pedal as a volume pedal. each preset can send 10 signals(functions) at once (5 prog. the fcb has 10 banks with each 10 presets. I'll try to explain (hopefully you don't mind) what I figured out and what I didn't figure out: I have an fcb 1010 to work with my VG-99 I'm trying to set it up but am experiencing some problems. PS Below are some of the other steps I've taken: If anyone can help I would be soooo grateful!! I have no clue what to do with device ID in VG 99 as i don't think the fcb mentions anything like that in the manual,Īnd I read on this forum something about using control assign to set the VG-99 to receive the correct CC. I press up, and down to leave this programming mode. Then I see green light above 'value 2' and make sure number display reads 127 Then I see green light above 'value 1' and make sure number display reads 00 If i select switch 8 the led starts blinking.Īnd I can choose a number ranging from 00-127 (the green light is above 'number') -> is this a CC number? I press the down key, press up and now I see that I have swith 1, 8 and 9 selected. Now I would like it if I could control it with my fcb. In preset 1 of my roland I have added the Wah pedal. I am however unsuccesful in making the expression pedals to work.įor instance I have selected preset 1 on my fcb and thus also on my roland. I am able to switch presets of my VG-99 with the FCB 1010, I can program the pedals to do what I want, so far so good.

Fcb1010 mainstage 3